Honda Accord

of release

Repair and operation of the car



Honda Chord
+ Cars of the Honda Accord brand
+ Settings and routine maintenance
+ Engine
- Cooling systems, heating
   Antifreeze - general information
   Check of serviceability of functioning and replacement of the thermostat
   Check of a condition of fans of the cooling system and chains of their inclusion, replacement of fans
   Removal and installation of a radiator and broad tank of the cooling system
   Check of a condition of the water pump
   Replacement of the water pump
   Check of serviceability of functioning and replacement of the block of the sensor of the measuring instrument of temperature of cooling liquid
   Check of serviceability of functioning of a driving electric motor of the fan of a heater and condition of components of its electric chain, replacement of components
   Removal and installation of an electric motor of the drive of the fan of a heater
   Removal and installation of assembly of the control panel of functioning of a heater and conditioner of air, adjustment of a driving cable
   Removal and installation of the heat exchanger of a heater
   Check of serviceability of functioning and service of systems of heating and air conditioning
   Check of an electric chain of a clutch coupling of the K/V compressor
   Removal and installation of a receiver dehumidifier To/in
   Removal and installation of the K/V compressor
   Removal and installation of the K/V condenser
   Removal and installation of the K/V evaporator with the broad valve
+ Power supply system and release
+ Engine electric equipment
+ Engine management
+ Gear shifting box
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Schemes of electric equipment



Removal and installation of an electric motor of the drive of the fan of a heater

 PERFORMANCE ORDER

1. Disconnect a negative wire from the battery.

Slee the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that you have the correct combination for input of the audio system in action!

2. Assembly of the fan of a heater is located under the car dashboard, behind a ware box, near a partition of a motive compartment. The driving electric motor, resistor knot and the motor of inclusion of the mode of the closed circulation are a part of assembly.

3. Disunite the socket of an electrical wiring of a driving electric motor and turn out three fixing screws. Remove the motor.

4. If the motor is subject to replacement, disconnect it from a krylchatka of the fan, - use nippers for an otpuskaniye and removal of a clamp. Rearrange a krylchatka on assembly of a new electric motor.

5. Installation is made upside-down. Check serviceability of functioning of the fan.