Honda Accord

of release

Repair and operation of the car

The handle is intended for the choice of the mode of distribution of air on salon.

Air supply via side deflectors of the dashboard is carried out in all modes. The general scheme of distribution of an air stream is submitted on an illustration.

External air comes to salon via the central and side ventilating deflectors of the dashboard.
External air comes to salon at the same time via the central and side ventilating deflectors in the control panel, and also through the lower air vents which provide air supply in driver's and passenger foot wells.
Supply of external air only driver's and passenger foot wells is carried out.

External air comes to salon at the same time through the nozzles of an obduv of a windshield which are built in in the control panel from above near the lower edge of glass and through the lower air vents of foot wells.
External air arrives on having blown in a windshield through the nozzles which are built in in the control panel from above near the lower edge of glass.

Control of deflectors of ventilating grates

Instructions for use of systems of ventilation, heating and air conditioning

Detailed maintenance instructions of systems of heating, ventilation and air conditioning in various climatic conditions are given below. Information on how to provide effective ventilation, heating and cooling of air in interior of the car, and also how quickly to remove from glasses a kondensant and hoarfrost is provided to attention of the reader.

All considered systems function only at the started engine. As a working body for a heater cooling liquid of the engine is used. If the engine is not heated-up up to the normal working temperature, several minutes before in salon warm air begins to move will be required. Operation of the air conditioning system does not depend on temperature of cooling liquid of the engine.

In absolute majority of cases the best efficiency of functioning of the systems providing a comfortable microclimate is reached in the giving mode in salon of external air, inclusion of the mode of the closed circulation, especially at the idle conditioner of air, leads to fogging of glasses and increase in a spertost of air therefore it is recommended to include this mode only in case of need and for rather short time, for example, at the movement on the area with the smoke-filled or polluted atmosphere. As soon as need of isolation of salon disappears, giving in salon of fresh air has to be resumed.

External atmospheric air comes to systems of heating and conditioning through the reception lattice located before a windshield and equipped with a fairing. Periodically clean openings of a reception lattice from leaves and the other garbage complicating air passing.

Ventilation of salon

The system of a supply and exhaust ventilation provides air in interior of the car. The fresh air arriving through a forward reception lattice circulates on salon and then is removed through the exhaust outlets located near back glass:

a) Turn the air temperature regulator handle counterclockwise against the stop. Check that the conditioner of air was switched on.
Ь) Install the handle of switching of the directions of air supply in situation. The mode of the closed air circulation has to be switched off.
c) By means of the handle of the choice of the high-speed mode of the fan establish the required intensity of air supply in salon.

Cooling of air in interior of the car

1 Cooling of salon is made as follows:

a) Turn on the air conditioner, having pressed the A/S button, - the control lamp which is built in the switch has to light up.
b) Check that the handle of the regulator of air temperature was turned in extreme left situation.
c) Install the handle of switching of the directions of air supply in salon.
d) At high humidity of external air include the mode of the closed circulation, at low humidity - the mode of inflow of fresh air;
e) By means of the handle of the choice of the high-speed mode of the fan establish the required intensity of air supply in salon.
2 If the car staid a long time in the sun and air in salon strongly heated up, to quickly reduce temperature in salon as follows:

a) Start the engine;
b) Turn on the air conditioner (A/S button). Check that the handle of the regulator of air temperature was turned in extreme left situation;

c) By means of the handle of the choice of the high-speed mode of the fan establish the maximum intensity of air supply in salon;
d) Partially slightly open windows and turn the handle of switching of the direction of distribution of air in situation. Include the mode of inflow of fresh air.

After air temperature in salon decreases to the acceptable level, close windows and set the normal mode of air conditioning

Operation of the air conditioning system leads to increase in load of the car engine therefore it is necessary to watch closely an arrow of the index of temperature of cooling liquid, moving with frequent stops and at a small speed in the conditions of an intense city cycle, or overcoming long raising of the considerable steepness. At approach of an arrow of the index to the red range of a scale, temporarily switch off the air conditioner until temperature of the engine does not return to norm.

Heating of interior of the car

To lift air temperature in interior of the car, execute the following manipulations:

a) Start the engine;
b) Install the handle of switching of the directions of distribution of air in situation. The mode of the closed air circulation has to be switched off;
c) By means of the handle of the choice of the high-speed mode of the fan establish the required intensity of air supply in salon;
d) Turning the air temperature regulator handle in that or to an inuyustoron, establish desirable degree
air.

Heating of salon with simultaneous drainage of air by means of the conditioner

During the work of air conditioning system humidity of air in interior of the car decreases therefore simultaneous inclusion of systems of heating and conditioning allows to make air in interior of the car warm and dry.
a) Turn on the fan;
b) Turn on the air conditioner;
c) Install the handle of switching of the direction of distribution of air in situation. The mode of the closed air circulation has to be switched off;
d) Pororachivy the air temperature regulator handle in this or that party, establish desirable extent of heating of the air coming to salon. In this mode cold air from the conditioner mixes up with warm air from a heater.

Joint inclusion of systems of heating and air conditioning can be applied in any traffic conditions when temperature of surrounding 0 °C.

Removal from glasses of condensate and hoarfrost

It is possible to clear the internal surfaces of glasses of the condensed moisture as follows:
a) Turn on the fan;
b) At the corresponding complete set of the car turn on the air conditioner;
c) Install the handle of switching of the directions of distribution of air in situation. The mode of the closed air circulation has to be switched off. Some options of execution of the car provide a possibility of automatic inclusion of the mode of supply of fresh air and its conditioner by installation of the handle of switching of the directions of distribution of air in situation
d) Turn the air temperature regulator handle in such situation that warm air moved through nozzles of an obduv of a windshield;
e) Include an electric heater of back glass for more bystry removal of the condensed moisture from its surface. On some options of execution of the car if the handle of switching of the directions of distribution of air is in any situation except, the conditioner of air remains included. For switching off of the conditioner press the А/С button.

To remove from an external surface wind and side glasses the hoarfrost or ice formed later parking of the car on the street in frosty weather, execute the following manipulations:

a) Include ignition, повернувключ in the lock in the provision of "ON" (II);
b) Install the handle of switching of the directions of distribution of air in situation. The mode of the closed air circulation has to be switched off. Some options of execution of the car provide a possibility of automatic inclusion of the mode of supply of fresh air and the conditioner, by installation of the handle of switching of the modes of the direction of distribution in situation;
c) Turn the air temperature regulator handle in an extreme pravoyepolozheniye (the maximum heating of air) and turn on the fan on the maximum speed;
d) Start the car engine.

For acceleration of cleaning of a windshield of hoarfrost or ice it is recommended to include the mode of the closed air circulation in very cold weather at first. After the windshield is exempted from frost, resume supply of fresh air for the purpose of prevention of fogging of glasses.

In the mode of an obduv of glasses all given to salon of air arrives through the slot-hole nozzles located from above on the dashboard at the windshield basis and also via side ventilating deflectors of the dashboard. Air temperature, an obduvayushchegostekla, and speed of purification of glasses increase in process of warming up of the engine. For acceleration of process of removal from a windshield of condensate, hoarfrost or ice it is possible to close side ventilating deflectors. In this case all air will go only on having blown in a windshield.

For reasons of safety it is not necessary to begin the movement until all windows of the car are not cleared of condensate, and the adequate review will not be provided to the driver.

Switching off of systems of heating and ventilation

In order that temporarily otklyuchitsistema of heating and ventilation, turn handles of regulators of the high-speed mode of the fan and air temperature in the extreme left provisions.

Need for shutdown of systems arises the first several minutes after start of the engine in cold weather as it provides more bystry warming up of the engine up to the temperature sufficient for effective functioning of a heater. You keep the fan in all other cases constantly included in order to avoid an air stagnation in salon.

System of climate control

The system of climate control can be included in a basic equipment of some models and performs functions of management of ventilation, air conditioning otopleniya in salon. The heater and the conditioner of air provide maintenance of the set air temperature. Besides, the system climate-kotrolya automatically carries out the choice of the high-speed mode of the fan and makes distribution of distribution of air depending on the set temperature.

The direction of the streams of air coming to salon from the central and side ventilating snuffled, it can be adjusted manually, by means of mobile deflectors of lattices, - rychazhka of control of deflectors are located in the middle of ventilating grates. At desire, air supply via side deflectors of the dashboard can a bytpolnost is stopped.

Functioning of system in the automatic mode

The control panel of functioning of systems of heating, ventilation and air conditioning on the models equipped with system of climate control