Honda Chord
+ Cars of the Honda Accord brand
+ Settings and routine maintenance
+ Engine
+ Cooling systems, heating
+ Power supply system and release
+ Engine electric equipment
+ Engine management
- Gear shifting box
+ 5-staged manual box of gear shifting (MBGS)
- 4-staged automatic transmission (AT)
Failure diagnostics of AT/CVT - the general information
Removal, installation and adjustment of a cable of gear shifting
Removal and installation of the lever of switching (selector) of transfers
System of blocking - the general information, check of a state, replacement and adjustment of an electromagnet of management
Adjustment and replacement of the sensor switch of provision of transmission
Check and replacement of electromagnetic valves of management of functioning of transmission
Removal and installation 4-staged and automatic transmission (AT)
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Schemes of electric equipment
|
Adjustment and replacement of the sensor switch of provision of transmission
CHECK
|
|
|
1. Access to the socket of an electrical wiring of the sensor switch is possible from a motive compartment.
|
|
2. Disunite the 10-contact socket of the sensor switch of provision of transmission. |
|
|
3. Check the socket for compliance of conditions of the sensor switch to the card of conductivity. You transfer the selector lever serially to each of provisions. |
4. At negative results of check make adjustment of the sensor switch. If it is not possible to adjust the sensor switch, replace it. |
|
ADJUSTMENT
|
|
|
1. Transfer the selector lever to situation "N" and weaken nuts of fastening of the sensor switch.
|
|
2. Disunite the 10-contact socket and connect an ohmmeter to plugs 1 and 3. |
3. Uncover and slightly weaken bolts of fastening of the sensor switch. Turn the sensor switch in situation "N", - the click has to sound, and the ohmmeter will record emergence of conductivity.
4. Tighten fixing bolts, establish into place a cover and connect the socket. |
|
REPLACEMENT
|
|
|
1. The car also establish to Poddomkratta it on props.
|
|
2. Disunite the 10-kontatkny socket. Turn out a bolt of the holder of a plait of an electrical wiring. |
3. Transfer the selector lever to situation "N".
4. Uncover the sensor switch of provision of AT, then turn out bolts of fastening of the sensor switch.
|
|
5. Transfer the new sensor switch to the situation corresponding to situation "N" make sure that the selector lever also is in situation "N". |
|
|
6. Put on the sensor switch an axis of management and, having tracked that it remained in situation "N", tighten fixing bolts. |
7. Connect an electrical wiring, record a plait and establish into place a cover.
8. Make sure that the engine is started only in provisions "N" and "P" of the lever of the selector. |
|
|
|