Honda Accord

of release

Repair and operation of the car



Honda Chord
+ Cars of the Honda Accord brand
+ Settings and routine maintenance
+ Engine
+ Cooling systems, heating
- Power supply system and release
   Dropping pressure in a power supply system
   Check of serviceability of functioning of the fuel pump, measurement of pressure of fuel
   Check of a state and replacement of fuel lines
   Removal and installation of the fuel pump
   Check of a state and replacement of the sensor
   Removal and installation of the fuel tank
   Cleaning and repair of the fuel tank - general information
   Removal and installation of assembly of the air cleaner
   Removal, installation and adjustment of a cable of an accelerator
   System of electronic injection of fuel (EFI) - the general information
   Check of serviceability of functioning of system of injection
   Removal and installation of the case of a throttle
   Removal and installation of the regulator of pressure of fuel
   Removal and installation of the fuel highway and injectors of fuel
   System of release - the general information
+ Engine electric equipment
+ Engine management
+ Gear shifting box
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Schemes of electric equipment


Что за наказание это недержание

Removal and installation of the fuel pump

 PERFORMANCE ORDER

See preventions at the beginning of the Section Dropping Pressure in a power supply system.

1. Disconnect a negative wire from the battery.

If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that you have the correct combination for input of the audio system in action!

2. Dump pressure in a power supply system (see the Section Dropping Pressure in a power supply system).
3. Lift a floor carpet in the luggage compartment of the car.

4. Turn out bolts of fastening of a cover of access to the fuel tank.

5. Disconnect an electrical wiring from assembly. Having released clamps of sockets of bystry joining, disconnect fuel lines.

6. Give nuts of fastening of pump assembly.

7. Accurately take assembly from the fuel tank.
8. Disconnect an electrical wiring of assembly of the fuel pump.

9. Nippers squeeze clips of fastening of a fuel hose, - remove the top clip, lower shift to the middle of a hose, having completely released the pump union.

10. Remove the filtering element of a toplivozabornik from the lower end face of assembly.

11. Separate the pump from a basic arm.
12. Installation is made upside-down. Do not forget to replace sealing laying of a landing flange of assembly.