Honda Accord

of release

Repair and operation of the car


Honda Chord
+ Cars of the Honda Accord brand
+ Settings and routine maintenance
+ Engine
+ Cooling systems, heating
- Power supply system and release
   Dropping pressure in a power supply system
   Check of serviceability of functioning of the fuel pump, measurement of pressure of fuel
   Check of a state and replacement of fuel lines
   Removal and installation of the fuel pump
   Check of a state and replacement of the sensor
   Removal and installation of the fuel tank
   Cleaning and repair of the fuel tank - general information
   Removal and installation of assembly of the air cleaner
   Removal, installation and adjustment of a cable of an accelerator
   System of electronic injection of fuel (EFI) - the general information
   Check of serviceability of functioning of system of injection
   Removal and installation of the case of a throttle
   Removal and installation of the regulator of pressure of fuel
   Removal and installation of the fuel highway and injectors of fuel
   System of release - the general information
+ Engine electric equipment
+ Engine management
+ Gear shifting box
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Schemes of electric equipment


Check of a state and replacement of the sensor

 PERFORMANCE ORDER

See preventions at the beginning of the Section Dropping Pressure in a power supply system.

1. Disconnect a negative wire from the battery.

Slee the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that you have the correct combination for input of the audio system in action!

2. Take from a tank assembly of a gasoline pump with fuel consumption sensor (see the Section Removal and installation of the fuel pump).

3. By means of an ohmmeter measure resistance between assembly socket plugs.

It is necessary to choose the range of measurement of an ohmmeter in 200 Ohms. Write down indications of the measuring instrument in two extreme provisions of a float of assembly of the sensor of fuel consumption. Change of resistance has to happen to movement of a float evenly, without breakthroughs and delays.

4. At an empty tank (the lower provision of a float) resistance of the sensor has to make 105 ÷ 107 Ohms.
5. In the top provision of a float of the indication of an ohmmeter have to make 3 ÷ 5 Ohm.
6. At negative results of the check described above replace fuel consumption sensor.

REPLACEMENT

 PERFORMANCE ORDER

1. Disconnect a negative wire from the battery.

If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that you have the correct combination for input of the audio system in action!

2. Take from a tank assembly of the gasoline pump/sensor of fuel consumption (see the Section Removal and installation of the fuel pump).

3. Disconnect fuel consumption sensor block electrical wiring from the assembly basis.

4. Turn out fixing screws and separate fuel consumption sensor from a basic arm of assembly of a gasoline pump.

5. Installation is made upside-down. Do not forget to replace the sealing laying established under a landing flange of assembly.