Honda Accord

of release

Repair and operation of the car

Гормон роста

Check of serviceability of functioning and replacement of the switch of ignition and lock of blocking of a steering column

The models of cars considered in the present manual are equipped with system of additional safety (SRS). Before starting performance of any works near the block of a safety cushion, a steering column or the dashboard, disconnect SRS in order to avoid getting injured at its casual operation (see the Section of the Safety cushion - the general information). It is easy to distinguish an electrical wiring of a chain of SRS on yellow color of isolation.

Remove casings of a steering column and a knee emphasis (see the Head Kuzov).

CHECK

PERFORMANCE ORDER

1. Disconnect from the battery at first a negative wire, then positive.

If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that you have the correct combination for input of the audio system in action!

2. Remove the lower section of the dashboard from the driver's party of the car (see the Head Kuzov). Moving on an electrical wiring plait from the ignition switch along a steering column to the left assembly block down, disunite the electric socket.
3. Check the socket for existence of conductivity between contact plugs in each of provisions of the ignition key.

4. At identification of violations in distribution of conductivity replace the switch.
5. Make sure of density of landing of the cylinder of the lock in all provisions of a key and correctness of placement of marking. The worn-out lock will divide to replacement.

REPLACEMENT

Ignition switch

PERFORMANCE ORDER

2. Remove the top and lower sections of a casing of a steering column (see the Head Kuzov).
3. Insert a key into the lock and turn it in position of LOCK (Blocking).

4. Turn out two fixing screws and remove assembly of the switch from a steering column.

Lock cylinder

PERFORMANCE ORDER

1. Remove top both covers of a casing of a steering column and the lower section of finishing of the dashboard (see the Head Kuzov).
2. Give fixing nuts and lower a column. At the corresponding complete set of the car disunite sockets of an electrical wiring of assembly of an immobilization of start.

3. Assembly of the lock is fixed in a column by two bolts with srezny heads which need to be drilled (use a drill on 4.8 mm).

4. Release a collar and remove the cylinder of castle assembly from a steering column. At the corresponding complete set of the car remove the start immobilization block from the old cylinder. Rearrange an immobilizator on the new cylinder.

When replacing for any reason of the device of an immobilization of start it is necessary to reprogram the module of management (RSM) in the conditions of car repair shop.

5. Start the replaceable cylinder on the regular place (without key) and strongly tighten new fixing bolts.
6. Insert a key into the cylinder and make sure of serviceability of functioning of assembly.
7. Tighten fixing bolts before cutting of their heads. At the corresponding complete set of the car connect an electrical wiring to the start immobilization device.
8. Further assembly is made as it should be, the return to an order of dismantle of the corresponding components.
9. In conclusion connect the battery (at first a positive wire, then negative).

home