Honda Accord

of release

Repair and operation of the car


Honda Chord
+ Cars of the Honda Accord brand
+ Settings and routine maintenance
+ Engine
+ Cooling systems, heating
+ Power supply system and release
+ Engine electric equipment
+ Engine management
+ Gear shifting box
- Coupling and power shafts
   Coupling - the general information and check of a condition of components
   Removal and installation of the main cylinder of coupling
   Removal and installation of the executive cylinder of coupling
   Removal of air from a hydraulic path of the drive of switching off of coupling
   Removal, check of a state and installation of components of assembly of coupling
   Removal, check of a state and installation of the release bearing and fork of switching off of coupling
   Adjustment of a pedal of coupling
   Check of a state, replacement and adjustment of the sensor switch of disconnection of a chain of a starter
   Removal and installation of power shafts
   Removal and installation of an intermediate shaft
   Replacement of protective covers and check of a condition of CV JOINTS
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Schemes of electric equipment

нужна виза в китай

Removal and installation of the main cylinder of coupling

REMOVAL

 PERFORMANCE ORDER

1. Disconnect a negative wire from the battery.

If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that you have the correct combination for input of the audio system in action!

2. Under the dashboard take a pin and disconnect a cutting finger of a pusher of the main hydraulic cylinder from a coupling pedal.

3. Disconnect the tank of the main cylinder of coupling. Самоконтрящимися nippers press the giving hose connecting the tank to the main cylinder.

Hose it is necessary to press at distance about 5 cm from a cut of the end cylinder tense on the union. Disconnect a hose from the tank, turn out a fixing bolt and take assembly of the tank from a motive compartment.

4. Release a fixing collar and disconnect the hydraulic line from the main cylinder. For the purpose of minimization of losses of hydraulic liquid wind nipple knot with rags. At once to a zakuporta the open ends of the line and the union in order to avoid hit in system of dirt.

In order to avoid damage of a paint and varnish covering, do not allow hit of hydraulic liquid on the painted surfaces of body panels.

5. Remove the power relay installed in a wheel arch with the arm.

6. In interior of the car under the dashboard give two nuts of fastening of the main cylinder to a partition of a motive compartment. Remove the cylinder from the car.

INSTALLATION

 PERFORMANCE ORDER

1. Start the main cylinder on the regular place and fix it by bolts, having by hand tightened nuts of the last.
2. Restore initial connection of hydraulic lines. Tighten fixing collars.
3. Strongly tighten fixture and the union of the hydraulic line. Tighten nuts of fastening of the cylinder with the required effort.
4. Connect a cylinder pusher to a pedal of coupling and record a new pin a cutting finger.
5. Install on the regular place the power relay with an arm.
6. Remove the nippers pressing the giving hose. Fill in necessary amount of the DOT 3 brake fluid in the tank, then give from a path air traffic jams (see the Section Removal of Air from a hydraulic path of the drive of switching off of coupling).