Honda Accord

of release

Repair and operation of the car



Honda Chord
+ Cars of the Honda Accord brand
+ Settings and routine maintenance
+ Engine
+ Cooling systems, heating
+ Power supply system and release
+ Engine electric equipment
+ Engine management
+ Gear shifting box
- Coupling and power shafts
   Coupling - the general information and check of a condition of components
   Removal and installation of the main cylinder of coupling
   Removal and installation of the executive cylinder of coupling
   Removal of air from a hydraulic path of the drive of switching off of coupling
   Removal, check of a state and installation of components of assembly of coupling
   Removal, check of a state and installation of the release bearing and fork of switching off of coupling
   Adjustment of a pedal of coupling
   Check of a state, replacement and adjustment of the sensor switch of disconnection of a chain of a starter
   Removal and installation of power shafts
   Removal and installation of an intermediate shaft
   Replacement of protective covers and check of a condition of CV JOINTS
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Schemes of electric equipment



Check of a state, replacement and adjustment of the sensor switch of disconnection of a chain of a starter

CHECK

 PERFORMANCE ORDER

1. The sensor switch of disconnection of a chain of a starter is located near the top end of a pedal of coupling. Two wires, one - from the relay of inclusion of a starter, by the second - weight are brought to the sensor switch. When turning the ignition key in situation START and squeezing of a pedal of coupling, due to operation of the sensor switch, there is a short circuit on the mass of the relay of a starter that leads to activation of an electric motor of the last.

2. If the engine is not turned at the squeezed-out coupling pedal, it is necessary to make adjustment of the sensor switch, then to repeat attempt. If adjustment does not help to achieve desirable result, check a condition of the sensor switch and in case of need replace the last. If the engine is started at the released coupling pedal, adjust the sensor switch and repeat attempt.
3. If when squeezing a pedal of coupling the engine is not turned, therefore, or conductivity between sensor switch plugs is broken, or on the last the power supply from the starter relay does not move.
4. Check serviceability of giving of food by means of the voltmeter or a lamp sampler. When turning the ignition key in situation START and squeezing of a pedal on the wire going from the relay of a starter tension has to take place. If tension is absent, check for break an electrical wiring between the relay and the sensor switch. If food moves regularly, check presence of tension from the opposite side of the sensor switch (at the squeezed-out coupling pedal). Presence of tension on both sides of the sensor switch confirms serviceability of its functioning. Try to make adjustment. In the absence of tension replace the sensor switch.

REPLACEMENT

 PERFORMANCE ORDER

Disunite the electrical wiring socket, weaken an adjusting nut and turn out the sensor switch from the basic arm. Installation is made upside-down.

ADJUSTMENT

 PERFORMANCE ORDER

Weaken a lock-nut and, rotating the sensor switch, achieve existence of conductivity between its plugs at the squeezed-out coupling pedal.