Honda Accord

of release

Repair and operation of the car



Honda Chord
+ Cars of the Honda Accord brand
+ Settings and routine maintenance
- Engine
   + Four-cylinder engines
   + V6 engines
   - General and capital repairs of the engine
      Check of pressure of oil
      Check of compression pressure in cylinders
      Diagnostics of a condition of the engine with use of the vacuum gage
      Removal of the power unit from the car - preparation and precautionary measures
      Removal and installation of the engine
      Alternative versions of schemes of recovery repair of the engine
      Order of dismantling of the engine by preparation it to capital repairs
      Dismantling of a head of cylinders
      Cleaning and check of a condition of a head of cylinders
      Service of valves
      Assembly of a head of cylinders
      Removal and check of a condition of balancing shaft (4-cylinder engines)
      Removal of conrod and piston assemblies
      Removal of a bent shaft
      Cleaning of the block of the engine
      Check of a condition of the block of the engine
      Honingovaniye of mirrors of cylinders
      Check of a condition of components of conrod and piston group
      Check of a condition of a bent shaft
      Check of a state and selection of inserts of radical and conrod bearings of a bent shaft
      Engine assembly order
      Installation of piston rings
      Installation of a bent shaft and check of working gaps of radical bearings
      Installation of a back epiploon of a bent shaft
      Installation of conrod and piston assemblies and check of size of working gaps in conrod bearings of a bent shaft
      Installation of balancing shaft (four-cylinder engines)
      Trial start and running in of the engine after capital repairs
+ Cooling systems, heating
+ Power supply system and release
+ Engine electric equipment
+ Engine management
+ Gear shifting box
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Schemes of electric equipment



Installation of balancing shaft (four-cylinder engines)

 PERFORMANCE ORDER

1. Accurately directing, lay carefully wiped and greased balancing shaft in the engine block. Try not to damage bearing surfaces.
2. Having established a forward balancing shaft and приболтив his holder, install into place the oil pump.
3. Establish a cogwheel of a forward balancing shaft and, having blocked a back shaft a bolt or the screw-driver (see the Section Removal and check of a condition of balancing shaft (4-cylinder engines)), put and you priboltit the conducted gear wheel of a back shaft.

4. Grease persistent surfaces of the leader and the pure molibdensoderzhashchy lubricant conducted gear wheels. Achieve combination of a flute on a back flange of a cogwheel with the index on a gear wheel casing, then put a casing on the block, entering at the same time gear wheels into gearing, - the cogwheel can be developed slightly clockwise.

5. After the casing of a gear wheel is established, check that the tag on a cogwheel was combined with the index on a cover of the oil pump. If this condition is satisfied, screw fixing bolts and tighten them with the required effort.

6. The description of the procedure of installation of a belt of the drive of balancing shaft is provided in appropriate section of the present Chapter.