Honda Accord

of release

Repair and operation of the car



Honda Chord
+ Cars of the Honda Accord brand
+ Settings and routine maintenance
+ Engine
+ Cooling systems, heating
+ Power supply system and release
- Engine electric equipment
   General information and precautionary measures
   Start of the engine from the auxiliary power supply
   Check of a state and replacement of the battery
   Check of a state and replacement of wires of the battery
   System of ignition - the general information
   Check of functioning of system of ignition
   Check of a state and replacement of the coil of ignition
   Check of serviceability of functioning and replacement of the module of management of ignition (ICM)
   Removal and installation of the distributor of ignition
   Check of installation of a corner of an advancing of ignition
   System of a charge - the general information and precautionary measures
   Check of a condition of system of a charge
   Removal and installation of the generator
   Replacement of the regulator of tension and brushes of the generator
   System of start - the general information and precautionary measures
   Check of serviceability of functioning of a starter on the car (in situ)
   Removal and installation of a starter
   Removal and installation of the traction relay
+ Engine management
+ Gear shifting box
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Schemes of electric equipment





Replacement of the regulator of tension and brushes of the generator

In the present Section the description of the procedure measurements of brushes and the regulator of tension is given in the Nippondenso generators installed on 4-cylinder models. Replacement of the regulator on the V6 models is made complete with the production Mitsubishi/Delphi generator.


Remove the generator from the car (see the Section Removal and installation of the generator) and transfer it to a workbench.

Brushes

 PERFORMANCE ORDER

1. Give three fixing nuts and remove a back cover of the generator, also give a fixing nut and remove the terminal insulator.

2. Turn out two screws of fastening of the brush holder.

3. Remove the brush holder from a back end face of the generator.

4. Measure length of a vystupaniye of each of brushes from the boss in the holder and compare results of measurements to requirements of Specifications. If the size of a vystupaniye of brushes goes beyond the lower bound of admissible range, make their replacement.

5. Check freedom of the course of brushes in the holder's cartridges.
6. At installation of the brush holder into place wring out brushes the small screw-driver for a shaft transmission.
7. Screw and tighten fixing screws.
8. Establish into place a back cover and strongly tighten three fixing nuts.
9. Install into place the terminal insulator and tighten a nut of its fastening.
10. Install the generator on the regular place (see the Section Removal and installation of the generator).

Tension regulator

 PERFORMANCE ORDER

1. Perform the procedures described above in paragraphs with 1 on 3. Turn out screws of fastening of the regulator to a back frame of assembly of the generator.

2. Remove the regulator from assembly of the generator.
3. Installation is made upside-down.