|
1. Weaken nuts of fastening of the corresponding back wheel. A car back also establish to Poddomkratta it on props. Remove a wheel.
2. Remove a brake drum / support with a disk (see the Head the Brake system).
3. By means of the hammer and a chisel remove a dustproof cover, then a raschekanta a stupichny nut.
4. By means of a face key with a long collar give a stupichny nut.
|
|
5. Remove a nave with the wheel bearing which is built in in it from stupichny assembly of the back bridge. If the nave "stuck", tap it the hammer with soft brisk. |
|
|
6. Establish new assembly of a nave with the bearing on the regular place. With the required effort tighten a new stupichny nut. Do not forget to fuller a nut. |
7. Establish into place a dustproof cover, for reliability of landing having slightly tapped it on perimeter.
8. Further installation is made as it should be, the return to an order of dismantle of components. Track that fixture of components of the brake mechanism was tightened with the required effort (see Specifications to the Head the Brake system). Efforts of tightening of wheel nuts are given in Specifications to the Head Nastroyki and routine maintenance. |