Honda Accord

of release

Repair and operation of the car



Honda Chord
+ Cars of the Honda Accord brand
+ Settings and routine maintenance
- Engine
   + Four-cylinder engines
   - V6 engines
      Preparatory actions and the list of repair procedures which can be executed without extraction of the engine from the car
      Reduction of the piston of the first cylinder in the provision of the top dead point (TDP)
      Removal and installation of covers of heads of cylinders
      Removal and installation of the inlet pipeline
      Removal and installation of final collectors
      Removal, check of a state and installation of a gas-distributing belt and cogwheels of the GRM drive
      Replacement of a forward epiploon of a bent shaft
      The VTEC system - the general information
      Removal, check of a state and installation of assembly of yokes
      Removal, check of a state and installation of camshafts
      Replacement of maslootrazhatelny caps and valvate springs with plates
      Removal and installation of heads of cylinders
      Removal and installation of the pallet of a case of the engine
      Removal, check of a state and installation of the oil pump
      Removal and installation of a driving disk
      Replacement of a back epiploon of a bent shaft
      Check of a state and replacement of support of a suspension bracket of the power unit (V6 Engines)
      System of correction of a suspension bracket of the power unit - the general information and check of serviceability of functioning
   + General and capital repairs of the engine
+ Cooling systems, heating
+ Power supply system and release
+ Engine electric equipment
+ Engine management
+ Gear shifting box
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Schemes of electric equipment



Removal and installation of a driving disk

 PERFORMANCE ORDER

1. Remove transmission (see the Head Korobk of gear shifting).

The engine should be hung out from above on the winch or the And-shaped beam.

2. Turn out bolts of fastening of a driving disk to a bent shaft.
3. Carefully wipe the removed disk with the rags moistened in acetone, having completely removed from it traces of oil and lubricant. Check a working surface of a disk for existence of cracks and other mechanical damages. Minor defects can be eliminated by means of a fine-grained emery paper. Check a gear wreath for existence of cracks and chips of teeths. Lay a disk on a flat surface for the purpose of assessment of its planeness (use the planeness measuring instrument). In case of need give assembly to a pro-point.
4. Wipe the interfaced surfaces of a driving disk and a bent shaft. If signs of leak of oil through a back epiploon of a bent shaft take place, make its replacement (see the Section Replacement of a Back Epiploon of a Bent Shaft).
5. Establish a driving disk on a bent shaft.

Fixing openings are located asymmetrically that guarantees unambiguity of landing of assembly. Before rolling fixing bolts, grease their carving part with the fixing sealant.

6. Tighten fixing bolts with the required effort in strictly certain order.

7. Further installation is made as it should be, the return to an order of dismantle of components.