Honda Accord

1. Lift a windowpane, then remove the panel of an internal upholstery of a door and the moisture filter (see the Section Removal and installation of panels of an internal upholstery of doors).

2. Through a big opening in a doorframe disconnect the rod connecting the external handle to a latch. Do the same with a rod of the internal handle, and also with rods of external and internal locks and (at the corresponding complete set) the electromagnetic actuation mechanism.

3. All rods fasten by means of plastic clamps. Release the part of a clamp entering gearing with a rod, then pull a rod, releasing it from a landing opening. On the models equipped with the uniform lock disconnect the corresponding electrical wiring from assembly of a latch.

4. Turn out screws of fastening of a latch to a door. Take assembly of a latch through the opening provided in a doorframe.

5. Installation is made upside-down.

1. Close a window and remove the panel of an internal upholstery of a door and the moisture filter (see the Section Removal and installation of panels of an internal upholstery of doors).

In order to avoid damage of a paint and varnish covering of the door panel paste over with an adhesive tape a window under landing of the door handle.

2. Through a special opening in a doorframe release plastic clamps of fastening to a latch of executive rods external the handle and the lock of a door. 3. Take caps, then turn out bolts of fastening of the external handle.

4. Remove the handle assembled with the lock cylinder. In case of need the cylinder can be taken from assembly by a clamp otpuskaniye. At the corresponding complete set of the car the socket of an electrical wiring is removed by an otdavaniye of a fixing bolt.

5. Installation is made upside-down.