Honda Accord

1. The IAT sensor represents a thermistor (the resistor which resistance depends temperatures). Change of resistance involves change of amplitude of alarm tension of the sensor, and, than temperature, subjects BELOW resistance and vice versa is HIGHER. Failures of the sensor lead to record in memory of system of self-diagnostics of a code of malfunction of P0112 or P0113.
2. Check IAT sensor resistance. Disunite the socket of an electrical wiring of the sensor located on the inlet pipeline.

3. By means of an ohmmeter measure resistance between two plugs on the sensor. Resistance of the sensor depends on temperature and at 20 °C has to make about 2500 ÷ of 3500 Ohms. Start the engine (or take the sensor and warm up it the hair dryer). At 83 °C resistance of the sensor has to decrease to the Ohm value 250 ÷ 350. At negative results of check replace the IAT sensor.

If at the disconnected sensor the engine worked, do not forget to clear memory of system of self-diagnostics (see the Section System of Onboard Diagnostics (OBD) - the principle of functioning and codes of malfunctions).

1. Disconnect a negative wire from the battery.

If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that you have the correct combination for input of the audio system in action!

2. Disconnect an electrical wiring from the IAT sensor.
3. Remove the sensor from a casing of the delivery camera of an inlet air path.
4. Installation is made upside-down.