|
Honda Accordof releaseRepair and operation of the car |
|
Honda Chord + Cars of the Honda Accord brand + Settings and routine maintenance - Engine - Four-cylinder engines Preparatory actions and the list of repair procedures which can be executed without extraction of the engine from the car Reduction of the piston of the first cylinder in the provision of the top dead point (TDP) Removal and installation of a cover of a head of cylinders The VTEC system - the general information and check of a condition of components Removal, check of a state and installation of assembly of yokes Replacement of maslootrazhatelny caps and valvate springs with plates Removal and installation of the inlet pipeline Removal and installation of a final collector Removal, check of a state and installation of cogwheels and belt of the drive of balancing shaft Removal, check of a state and installation of a gas-distributing belt and cogwheels of the GRM drive Replacement of a forward epiploon of a bent shaft Removal, check of a state and installation of the camshaft Removal and installation of a head of cylinders Removal and installation of the pallet of a case of the engine Removal, check of a state and installation of the oil pump Removal and installation of a flywheel / driving disk Replacement of a back epiploon of a bent shaft Check of a state and replacement of support of a suspension bracket of the power unit System of correction of a suspension bracket of the power unit - the general information and check of serviceability of functioning + V6 engines + General and capital repairs of the engine + Cooling systems, heating + Power supply system and release + Engine electric equipment + Engine management + Gear shifting box + Coupling and power shafts + Brake system + Suspension bracket and steering + Body + Onboard electric equipment + Schemes of electric equipment Лечение головных болей |
System of correction of a suspension bracket of the power unit - the general information and check of serviceability of functioning General information All models equipped with AT are equipped with system of electronic control by adjustment of parameters of a back support of the power unit. Under control parameter is the level of vibrations of the unit at single turns of the engine. In assembly of a support there are two cameras filled with working liquid. When the engine works at single turns the module of management of functioning of the power unit (RSM), develops the command for inclusion of the motive compartment of the electromagnetic valve operating giving of depression from the inlet pipeline in a back support of a suspension bracket of the power unit established on a back partition. Change of depth of the depression given to assembly leads to redistribution of working liquid between internal cameras of a support that allows in an essential measure to reduce the level of the vibrations transferred from the engine to a car body. At rise in frequency of rotation of the engine over 1000 rpm giving of depression is blocked and the support passes into the passive mode of functioning, working as a usual depreciation pillow.CHECK
|
|