Honda Accord

of release

Repair and operation of the car



Honda Chord
+ Cars of the Honda Accord brand
+ Settings and routine maintenance
- Engine
   - Four-cylinder engines
      Preparatory actions and the list of repair procedures which can be executed without extraction of the engine from the car
      Reduction of the piston of the first cylinder in the provision of the top dead point (TDP)
      Removal and installation of a cover of a head of cylinders
      The VTEC system - the general information and check of a condition of components
      Removal, check of a state and installation of assembly of yokes
      Replacement of maslootrazhatelny caps and valvate springs with plates
      Removal and installation of the inlet pipeline
      Removal and installation of a final collector
      Removal, check of a state and installation of cogwheels and belt of the drive of balancing shaft
      Removal, check of a state and installation of a gas-distributing belt and cogwheels of the GRM drive
      Replacement of a forward epiploon of a bent shaft
      Removal, check of a state and installation of the camshaft
      Removal and installation of a head of cylinders
      Removal and installation of the pallet of a case of the engine
      Removal, check of a state and installation of the oil pump
      Removal and installation of a flywheel / driving disk
      Replacement of a back epiploon of a bent shaft
      Check of a state and replacement of support of a suspension bracket of the power unit
      System of correction of a suspension bracket of the power unit - the general information and check of serviceability of functioning
   + V6 engines
   + General and capital repairs of the engine
+ Cooling systems, heating
+ Power supply system and release
+ Engine electric equipment
+ Engine management
+ Gear shifting box
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Schemes of electric equipment



Removal and installation of a final collector

REMOVAL

 PERFORMANCE ORDER

1. Disconnect a negative wire from the battery.

If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that you have the correct combination for input of the audio system in action!

2. A car front also establish to Poddomkratta it on props. Disconnect a reception pipe of system of production of the fulfilled gases from a final collector. If fixture of a pipe does not give in to an otdavaniye, previously moisten it with the getting structure.

3. Remove the thermofilter from a final collector. It is also expedient to impregnate fixture with previously getting structure.

4. Give fixing nuts and separate a final collector from a head of cylinders.

Do not forget to give bolts of the lower assembly bracket located near a fixing flange of a collector.

INSTALLATION

 PERFORMANCE ORDER

1. You will throw out old laying, then scratch out its fragments from the interfaced surfaces of a final collector and a head of cylinders. Wipe surfaces with the rags moistened in acetone.
2. Having replaced laying, establish a collector on the regular place and fix it by nuts. Moving in the direction from the center outside, in diagonal tighten fixture with the required effort (see Specifications).
3. Further installation is made as it should be, the return to a dismantle order.
4. Start the engine and check it for existence of signs of leak of the fulfilled gases through joints of a final collector with a head of cylinders and a reception pipe of system of release.